mustang question

[K&C Customs old]

1991 Mustang Gt 24 lb Injectors, LongTube Headers, Underdrive Pulleys, Eldelbrock Upper and Lower Intakes, pro 5.0 shifter, Bbk 70 mm throttle body, 1 chamber Flow masters, Ford Racing 9mm Plug wires, 3:73 gear, Cold Air Intake, Trick flow Stage 1 Cam, Stock bottom end, msd blaster coil, Aluminum Drive shaft, all smog removed and a/c and power steering removed, stock heads for now but will be changed soon... how should this setup run?

also will i tell any difference in idle or performance between the trickflow stage 1 cam and E-303?

im hoping to have a low 8 sec ride on slicks...

[Gone In 5 Seconds]

I went 8.0s on drag radials with an almost identical setup. I had an E cam though.

[vortech_95-gt]

8.20's should be no problem at all. Actually if it hooks relatively well and you can drive / shift the heck out of it then it actually could go a little faster like gonein5 mentioned he had done. Ive seen combos milder than that go 7.90's in a fox coupe. Redbull had one with stock intake and e-7 heads that went 7.90's with a small cam. heads and intake were ported and heads were also milled a good bit , Gear and a 5 speed. Come to think of it his car may have been faster than 7.90's i dont remember. Its been about 3 or 4 years ago
Chris