BB KoncepZ
04-30-2008, 07:55 PM
lookin to sell my 2004 Torch Red KB Cobra.
located in the Anniston/Oxford area of Alabama.
little over 10k miles and has the dark interior.
my email is kindbras@aol.com for any questions. if you need further info, PM me for my number.
the car valued in at $26k, then i have invested quite a bit into it. we jus finished up the car so all the parts are new and freshly installed.
some of the stock parts still available.
car made 660/606 at 25 PSI on pump 100 and Torco mix in the heat with a mild tune with almost no timing.
jus let me know if you have any questions. also, the picture below of the rear seat delete has a flaw in the picture on the right side where it looks to have a line in it but its not actually there.
thanks
here is a list of mods. im sure im forgettin some minor details. no certain order as i cant find my detailed list so i just listed them as they came to mind.
-tinted taillights by Jons Tinted tails(actual paint)
-5% LLumar tint on sides and rear. 30% Full Windshield with 5% Strip at top
-tinted marker lights
-Cobra bumper letters(gloss black)
-FAST overlay over ford emblem(black/chrome)
-18x9 and 18x10(deep dish) Bullits(black with machined lip) with
bullet lug nuts
-275/35/18 BFG KDW front tires
-315/30/18 BFG Drag Radials
-Maximum Motorsports 1/4'' wheel spacers
-Sylvania Silverstar bulbs- headlights and fog lights
-Cobra grille emblem
-chopped antenna
-HO Fibertrends Cowl hood
-Exhaust: Mac Long Tubs with off-road VRS x-pipe and Steeda Catback
-BilletFlow IRS brace(red)
-chopped factory springs
-Maximum Motorsports C/C plates
-LFP Dual Pass Heat Exchanger with SVT logo
-Gauges: AutoMeter Lunar boost and fuel pressure on a-pillar, and
AEM wideband on the steering column
-Raptor Shift light
-extra chin spoiler-brand new (just incase)
-various MGW interior pieces
-Steeda TRI-AX shifter
-rear seat delete(still have rear seat)
-SPEC 3+ Clutch, billet-steel flywheel, 26 spline input shaft,
ARP flywheel bolts, TOB retainer sleeve, etc...
-Steeda Double hook quadrant
-LDC head cooling mod
-oil separator
-Maximum Motorsports subframe connectors
-BILLETFLOW rear irs subframe braces(not installed)
-driveshaft loop(not installed)
-LFP intercooler tank with fuel cap
-Canton Coolant tank with red cap
-JLT high boost cold air(torch red) with valve-cover breather
-Accufab TB
-2.8H KB Supercharger(black)-various pullies
-NKG Tr7iX plugs gapped at .25
-Weapon-X COPs
-BilletFlow 4 piece idler setup(black)
-Metco 2 LB lower pulley
-Optima Red Top battery
-EGR Removed
-Fuel- Lethal/Fore Kit with Fore Fuel hat with GT pumps and twin -6 outlets
into a Aeromotive Fuel Filter with a single -8 to the front into
CPR rails with custom braided fuel crossover, etc...
-SCT tuned. comes with X-cal 2
-etc...
like i said, im sure there are several things im forgettin to list. im in the process of gettin my house back together so im not sure where my full list of mods is. basically with a good tune and a built rear end, the car should be a well rounded build.
lookin for $32,000 FIRM. shoot me any offers...
http://i261.photobucket.com/albums/ii61/crystaldenise87/TTM.jpg
http://i261.photobucket.com/albums/ii61/crystaldenise87/ttg.jpg
http://i261.photobucket.com/albums/ii61/crystaldenise87/tth.jpg
http://i261.photobucket.com/albums/ii61/crystaldenise87/ttk.jpg
http://i261.photobucket.com/albums/ii61/crystaldenise87/ttr.jpg
http://i261.photobucket.com/albums/ii61/crystaldenise87/ttty.jpg
http://i261.photobucket.com/albums/ii61/crystaldenise87/ttu.jpg
http://i261.photobucket.com/albums/ii61/crystaldenise87/tty.jpg
http://i261.photobucket.com/albums/ii61/crystaldenise87/ttyy.jpg
http://i261.photobucket.com/albums/ii61/crystaldenise87/ttd.jpg[/QUOTE]
located in the Anniston/Oxford area of Alabama.
little over 10k miles and has the dark interior.
my email is kindbras@aol.com for any questions. if you need further info, PM me for my number.
the car valued in at $26k, then i have invested quite a bit into it. we jus finished up the car so all the parts are new and freshly installed.
some of the stock parts still available.
car made 660/606 at 25 PSI on pump 100 and Torco mix in the heat with a mild tune with almost no timing.
jus let me know if you have any questions. also, the picture below of the rear seat delete has a flaw in the picture on the right side where it looks to have a line in it but its not actually there.
thanks
here is a list of mods. im sure im forgettin some minor details. no certain order as i cant find my detailed list so i just listed them as they came to mind.
-tinted taillights by Jons Tinted tails(actual paint)
-5% LLumar tint on sides and rear. 30% Full Windshield with 5% Strip at top
-tinted marker lights
-Cobra bumper letters(gloss black)
-FAST overlay over ford emblem(black/chrome)
-18x9 and 18x10(deep dish) Bullits(black with machined lip) with
bullet lug nuts
-275/35/18 BFG KDW front tires
-315/30/18 BFG Drag Radials
-Maximum Motorsports 1/4'' wheel spacers
-Sylvania Silverstar bulbs- headlights and fog lights
-Cobra grille emblem
-chopped antenna
-HO Fibertrends Cowl hood
-Exhaust: Mac Long Tubs with off-road VRS x-pipe and Steeda Catback
-BilletFlow IRS brace(red)
-chopped factory springs
-Maximum Motorsports C/C plates
-LFP Dual Pass Heat Exchanger with SVT logo
-Gauges: AutoMeter Lunar boost and fuel pressure on a-pillar, and
AEM wideband on the steering column
-Raptor Shift light
-extra chin spoiler-brand new (just incase)
-various MGW interior pieces
-Steeda TRI-AX shifter
-rear seat delete(still have rear seat)
-SPEC 3+ Clutch, billet-steel flywheel, 26 spline input shaft,
ARP flywheel bolts, TOB retainer sleeve, etc...
-Steeda Double hook quadrant
-LDC head cooling mod
-oil separator
-Maximum Motorsports subframe connectors
-BILLETFLOW rear irs subframe braces(not installed)
-driveshaft loop(not installed)
-LFP intercooler tank with fuel cap
-Canton Coolant tank with red cap
-JLT high boost cold air(torch red) with valve-cover breather
-Accufab TB
-2.8H KB Supercharger(black)-various pullies
-NKG Tr7iX plugs gapped at .25
-Weapon-X COPs
-BilletFlow 4 piece idler setup(black)
-Metco 2 LB lower pulley
-Optima Red Top battery
-EGR Removed
-Fuel- Lethal/Fore Kit with Fore Fuel hat with GT pumps and twin -6 outlets
into a Aeromotive Fuel Filter with a single -8 to the front into
CPR rails with custom braided fuel crossover, etc...
-SCT tuned. comes with X-cal 2
-etc...
like i said, im sure there are several things im forgettin to list. im in the process of gettin my house back together so im not sure where my full list of mods is. basically with a good tune and a built rear end, the car should be a well rounded build.
lookin for $32,000 FIRM. shoot me any offers...
http://i261.photobucket.com/albums/ii61/crystaldenise87/TTM.jpg
http://i261.photobucket.com/albums/ii61/crystaldenise87/ttg.jpg
http://i261.photobucket.com/albums/ii61/crystaldenise87/tth.jpg
http://i261.photobucket.com/albums/ii61/crystaldenise87/ttk.jpg
http://i261.photobucket.com/albums/ii61/crystaldenise87/ttr.jpg
http://i261.photobucket.com/albums/ii61/crystaldenise87/ttty.jpg
http://i261.photobucket.com/albums/ii61/crystaldenise87/ttu.jpg
http://i261.photobucket.com/albums/ii61/crystaldenise87/tty.jpg
http://i261.photobucket.com/albums/ii61/crystaldenise87/ttyy.jpg
http://i261.photobucket.com/albums/ii61/crystaldenise87/ttd.jpg[/QUOTE]