FS: SBC Edelbrock Performer heads

[L98vette]

This is the set I just took off the vette, they are now for sale. Im asking 450 for them. I cleaned them up a little, and they are ready to be either bolted on, or ported. They are for center bolt valve covers, if you need a set, I have some that I will throw in. The bolt pattern is for 87-up, but can be used w/ 86, and lower if you re-drill the middle bolt holes on the intake. This is what I did, and it worked well.
2.02 1.60 w/ 60 cc combustion chambers.

# 8 chamber has some very minor nicks in it, but nothing that will hender performance, or cause future damage. I have smoothed out the rough edges. The valves were not hurt.
They sell for 1099.99 New.
Part # 6085

[L98vette]

Unported
-----Int. Ext.
.100 64 54
.200 122 96
.300 177 124
.400 217 147
.500 229 166
.600 232 175

[L98vette]

305's can also benefit quite a bit from these ;)
Just dont go past .450 lift, or you will definately NOT like the results.

Source of info.
http://www.hotrodsusa.com/buynow/manufactures/edelbrock/automotive/headchev.html

[L98vette]

TTT

[Joe Dirt]

MAN WHAT IS YOUR BOTTOM DOLLAR ON THE HEADS?
I NEED TO GET MY OTHER MOTOR IN MY MUSTANG!
SINCE THE 305 LET GO ( FINNALLY) !!!!

[L98vette]

check your PMs

[Hotrod]

Pm me bottom dollar also,i might have someone intrested,or the work truck might need them.:nod:

[L98vette]

These units will be going on e-bay today around 5 or 6pm if no one contacts me, and advises to do otherwise before then. My #'s are posted above.
Thanks for all inquiries.

[Hotrod]

Consider them sold.Thanks.

[L98vette]

Originally posted by Hotrod
Consider them sold.Thanks.


Consider em yours, i'll see u firday.
Thanks again.

[Hotrod]

Thanks a bunch man.Good seeing you again.Good luck with the new motor.