L98vette
11-23-2004, 12:07 AM
This is the set I just took off the vette, they are now for sale. Im asking 450 for them. I cleaned them up a little, and they are ready to be either bolted on, or ported. They are for center bolt valve covers, if you need a set, I have some that I will throw in. The bolt pattern is for 87-up, but can be used w/ 86, and lower if you re-drill the middle bolt holes on the intake. This is what I did, and it worked well.
2.02 1.60 valves w/ 60cc combustion chambers
They sale for $1099.99 New.
Part # 6085
Flow #'s
Unported
-----Int. Ext.
.100 64 54
.200 122 96
.300 177 124
.400 217 147
.500 229 166
.600 232 175
__________________
305's can also benefit quite a bit from these
Just dont go past .450 lift, or you will definately NOT like the results.
Source of info.
http://www.hotrodsusa.com/buynow/ma...e/headchev.html <http://www.hotrodsusa.com/buynow/manufactures/edelbrock/automotive/headchev.html>
2.02 1.60 valves w/ 60cc combustion chambers
They sale for $1099.99 New.
Part # 6085
Flow #'s
Unported
-----Int. Ext.
.100 64 54
.200 122 96
.300 177 124
.400 217 147
.500 229 166
.600 232 175
__________________
305's can also benefit quite a bit from these
Just dont go past .450 lift, or you will definately NOT like the results.
Source of info.
http://www.hotrodsusa.com/buynow/ma...e/headchev.html <http://www.hotrodsusa.com/buynow/manufactures/edelbrock/automotive/headchev.html>