Is a Edelbrock 750 big enough for my mustang?

[E.ST]

I have a 1983 Mustang with a 302 bored 40 over with trw forged pistons 1.7 rockers 351 heads and a victor junior intake i need a new carb do you think that a Edelbrock 750 will let it preform the way it needs to?

[j-mill]

go with rochester quadrajet. it will put you in there. on sale at pull apart moreland ave.

[streetsweeper94]

go with rochester quadrajet. it will put you in there. on sale at pull apart moreland ave.

DAMN!

[vortech_95-gt]

I have a 1983 Mustang with a 302 bored 40 over with trw forged pistons 1.7 rockers 351 heads and a victor junior intake i need a new carb do you think that a Edelbrock 750 will let it preform the way it needs to?Id say that its probably a little too much. I had a 750 on a solid roller , 11.5:1 compression , ported victor junior head 347ci. Motor. Id say buy you a holley 650

[streetsweeper94]

I have a 1983 Mustang with a 302 bored 40 over with trw forged pistons 1.7 rockers 351 heads and a victor junior intake i need a new carb do you think that a Edelbrock 750 will let it preform the way it needs to?

IMO..............Edelbrocks are JUNK! Its hard to beat a well built carb., also a 650 is more than enuff.........again just opinions! If your from Cartersville I would think you know Troy. He has the hook up with the carb man of Cartersville

[331coupered]

Agreed holly hp 650, edelbrock sucks

[vortech_95-gt]

Agreed holly hp 650, edelbrock sucksyepper:bouncy:

[bigtyre187]

id use a predator 1000 or 2 1150 holleys and a magna flow 500 w 12an fuel line but remember adjust ur nos timing a mili sec and run 9 s

[Bonz]

I have a 1983 Mustang with a 302 bored 40 over with trw forged pistons 1.7 rockers 351 heads and a victor junior intake i need a new carb do you think that a Edelbrock 750 will let it preform the way it needs to?

600 holley