Jwagnon89
09-16-2009, 12:15 PM
I had the engine built by Delks performance of Lebanon TN in July. It has the 8 lb Metco lower blower pulley kit, new belts, new high current Ford alternator, Aeromotive fuel rails with braided fuel lines set up for a return style tank, with a Proffesional products fuel regulator set on 40 lbs with a fuel pressure gauge on the regulator, the factory s/c has been port matched to the heads, Arp head studs, 3 angle valve job, decked heads, 90mm mass air flow sensor, Diablo M.A.fia puck, 60lb injectors, and a New 14" K&N air filter. The engine, before all this work, only had 20k miles on it, so its basically new again, and I only got to drive it for about 500 miles. I have the 03 computer if you want to put it in a fox body or an SN-95 like I did, thats why the fuel system is ran the way it is, but the program on the cobra computer is still factory so you will still need it tuned for the injectors. If you do happen to want to put it in that body I have EVERYTHING you will need except the hood or tubular K member depending upon which route you take. I have over 5k in parts from delks with receipts to prove how new everything is, so I'll take my loss and sell it for $9k. Nothing is wrong with it for me to sell it, but I popped the hood to show it to someone and didnt latch the hood all the way and on the way home the hood flew off, busted the windshield, ripped the hinges out of the car, and caved the roof in. So take this incident as your gain and my loss, this thing is huge and needs to taken out of my shop. Please only serious buyers respond, you could also call or text me at 256 874 6306 Thanks Josh