Anybody have??

[88StangGT]

Anybody have some mill eliminators that will fit a 94 mustang gt or know where i can get some cheap. There the plugs that plug into where the sensors plug for the cats on the exhaust. I tried using the old sensors but with the new exhaust they wont reach so i have to put these eliminators on to get the check engine light off

[BlueOvalBoy]

Anybody have some mill eliminators that will fit a 94 mustang gt or know where i can get some cheap. There the plugs that plug into where the sensors plug for the cats on the exhaust. I tried using the old sensors but with the new exhaust they wont reach so i have to put these eliminators on to get the check engine light off


I am assuming this is a 5.0L I never heard of someone using mills on a 5.0.If you just want to extend the o2 wires due to longtubes you can go to www.50resto.com or someplace like that they are for longtubes and extending o2 wires

[57fairlane]

Mills are usually tough to do on your own.

You would have to disassemble the wheel and then the building . . .
Probably better to just burn it down.

[88StangGT]

only reason i want to do it is to get the check engine light off